Suitable for round and oval tubes Ø 12 – 27 mm.

Preparation:

1: Loosen the 2 bolts. Pull the metal bracket with the plastic block out of the footrest. Remove the metal bracket from the plastic block. Open the bracket and remove the block.

For installation:

2: Ensure the included sandpaper is in the curvature of the bracket. The sandpaper prevents the footrest from turning. To protect the paint, the grit should face towards the bracket. For optimal operation, the sandpaper can be reversed so that the grit faces the frame. This may cause paint damage.

3: Place the block (with the curved side toward the tube) between the metal bracket, making it as close as possible to the bike tube. The pins of the block must fall into the holes of the metal bracket.

4: Then slide the footrest over the plastic block. If the footrest does not fit over the block, check if the curved side of the block is not mounted against the tube.

5: Tighten the bolts securely (torque 6.0 Nm) with a hex key size 5. Repeat for the other footrest.